Inspection template in the LeanSuite app
Last reviewed
Insulation and heat loss inspection checklist
Inspection of insulation on pipes, tanks and ducts.
The full question list
The 7 questions in the inspection
Every question is answered Yes, No or N/A. Each No is flagged and asks for a photo and a comment, so the finding arrives with its evidence.
Check
- 1Insulation is intact and dry
- 2Hot surfaces are covered
- 3Valves and flanges are insulated
- 4No cold or hot spots found
Action
- 5Damage was logged
- 6Work orders raised
- 7Check signed
When to use it
- Once a month.
- The person responsible for the area or equipment answers each question on the spot.
- Each record starts with: Area.
How it is scored
The template is built with points per answer and a pass mark of 90. In this library every audit is set to pass at 80 and every inspection at 90. Each submitted inspection shows its score and pass or fail, and every No is flagged with its photo and comment.
Change the points or the pass mark after you clone it. How rules and scoring work.
Read and print
More in environment and energy
- Environmental inspection checklist13 questions
- Chemical dosing area inspection checklist7 questions
- Coolant and fluid management inspection checklist7 questions
- Dust collector inspection checklist6 questions
- Fuel storage inspection checklist11 questions
- Oil and water separator inspection checklist9 questions
Use this template in LeanSuite
It is ready in the Template Marketplace inside Lean Creator as “Insulation and Heat Loss Inspection”. Clone it into your plant, change any question, then schedule it to a person, role or asset with reminders. Auditors complete it on a phone or tablet, with photo evidence where required.
Not on LeanSuite yet? On a 90-day pilot our team sets up your account and digitizes the forms and checklists you use today, this one included.